If you have a broken car window it is essential to get it replaced as quickly as possible. Not only does a cracked window affect the structural integrity of the vehicle, but it also lowers visibility and increases the risk of accidents. In addition, it can leave your car open to weather elements and theft. Luckily, replacing a replace car window is not as difficult as you might think and there are a few options for getting it done.
If your car has an insurance policy then the cost of a replacement may be covered by the insurance provider. It is worth checking this out because there are several companies that specialize in working with car windows and will replace them for a reasonable price. You should always call around to get multiple quotes and check to see which company offers the best value for your money.
When you are ready to replace your car window it is essential that you do everything in a safe manner and have the proper tools. This includes wearing work gloves and safety glasses and ensuring that the area where you are working is secure from other hazards. It is also recommended that you cover the broken window with a plastic bag or tarp in order to prevent rain and other elements from damaging your vehicle while you are working on it.
Before you start the work of replacing your car window you should remove all of the components that hold it in place. This will include the inner door panel, window-height-regulator mechanism and window motor. You should consult your service manual to find out how to do this. It can be a bit tricky to figure out where to access the bolts, screws or clips that keep these items in place. They can be hidden behind trim pieces or connected to other components that need to be disconnected. You should also use this time to clean any glass shards from the interior of the door. This will make your job much easier in the long run.
Once you have the necessary tools and have a clear understanding of how to replace your car window you should begin work on the project. You will need to carefully peel back the vapor barrier and access the inner door panels. From there you should raise or lower the window height regulator mechanism to a position where the bolts or screws holding the glass remnants to the regulator align with the access holes stamped in the steel. Then you should disconnect the plug that powers the window regulator and motor and strip off the bottom seal to open up the slot for the new window.
Once you have access to the window slots it should be a simple matter of sliding the new window in place. It is important that you remember not to use too much force because the window can break if it is treated carelessly. Once the new window is in place you should re-attach all of the other hardware and re-install the vapor barrier.